Les médias
30 ans d'histoire de la marque
Plus de 100 agents dans le monde
Équipement de traitement allemand
Dix séries de marchés publics à guichet unique
HDPE Pipe Tracer Wire: Specify a Locatable Main, Not Just a Wire
Compare actual utility tracer-wire clauses and distinguish electrical continuity from a completed locate. Build a clear HDPE-main acceptance brief.
HDPE Borehole Rising Main: Check the Load Path Before Accepting a PN Rating
Screen an HDPE borehole rising main by separating pressure, hanging load and wellhead support. Learn what a PN-only offer leaves unresolved.
Will an HDPE Cold Bend Fit? Check Radius, Tangents and Fittings Before Drawing the Route
Screen an HDPE route using bend radius, tangent setback and arc length. See why a fitting can change the result before a project engineer approves it.
IPS or DIPS? Resolve a Conflicting HDPE Tender Before Ordering
Resolve conflicting IPS and DIPS HDPE callouts before release. Use real bidder clarifications to distinguish a correction from an approved substitute.
Can This HDPE Water Pipe Be Squeezed Off? Check Eligibility Before Choosing the Tool
Screen an HDPE water pipe for squeeze-off planning. Match pipe, tool and procedure; check location and separate water guidance from gas standards.
Barrier Water Pipe Fittings: Why a Standard PE Reducer May Not Fit
Check barrier-pipe diameters, approved inserts and contamination protection before reducing to ordinary PE. See what a 32-to-25 mm transition must prove.
PVC-O Pipe to ISO 16422: Class, Pressure and Joint Evidence
Check PVC-O pipe offers against ISO 16422: standard parts, material class, pressure, dimensions and joint evidence before approving a purchase.
EN 10204 3.1 for Plastic Pipe: Agree the Inspection Plan
Buying plastic pipe with an EN 10204 3.1 requirement? Agree batch evidence, tests, signing roles and document acceptance before manufacture.
EN 13501 for Plastic Pipe: Check the Report Before Buying
Check plastic-pipe Euroclass reports, product coverage and the applicable CPR declaration route before accepting a European project quotation.
Specifying a Pressure Reducing Valve: Set Pressure, Fall-Off, Cv and the Two Numbers a Datasheet Can Leave Off
Most PRV mistakes start with the pipe size: a 3/4 in line gets a 3/4 in valve, and nobody checks it at peak flow. Specify a pressure reducing valve by flow instead. Name a set pressure at or below the 80 psi static ceiling in IPC 604.8 and UPC 608.2, the fall-off at your design
EN 13828 and EN 13618: The Ball-Valve and Braided-Hose Tests a Buyer Should Ask to See
EN 13828:2025 covers brass ball valves, EN 13618:2016 braided hoses. Scope, 2025 changes, the tests each report must list, and the hygiene gap.
Coil or Straight Length? The HDPE Ordering Decision That Changes Your Freight, Your Ovality and Your Site Labour
Order HDPE pipe in coils when the bore is small and the run is long. Most pipe of 4 in and smaller can be coiled. Coils are typically limited to 6 in and smaller in US practice and to 180 mm in metric practice, and one coil can put several hundred metres in the ground
Français 
English 
Русский 
Español